Appendix III. BASIC ISSUE ITEMS LIST

(4) Screw spraybar nipple (40) into elbow (18) and coupling half (38).

(5) Connect spraybar (3) at coupling (38).

(6) Screw spraybar extensions (24 and 25) into coupling halves (22) and connect couplings.

Installation.

(1) Replace extension pivot (21) on pivot spool (19) and secure with locknuts (20).

(2) Connect spraybar extension (24) to coupling (22) at extension pivot (21).

(3) Replace nipple (13) in spraybar Y -bend (14).

(4) Replace hoses (9) on nipple (13) and elbow (8) and secure with clamps (10).

Page 109.

Appendix III is superseded as follows:

APPENDIX III

BASIC ISSUE ITEMS LIST

Section 1.

INTRODUCTION

1. Scope

This appendix lists items which accompany the water distributor or are required for installation, operation, or operator's

maintenance.

2. General

This Basic Issue Items List is divided into the following sections:

a. Basic Issue Items - Section II. A list of items which accompany the water distributor or are required for the

installation, operation, or operator's maintenance.

b. Maintenance and Operating Supplies - Section III. A listing of maintenance and operating supplies required for

initial operation.

Explanation of Columns

The following provides an explanation of columns in the tabular list of Basic Issue Items, Section II.

a. Source, Maintenance, and Recoverability Codes (SMR), Column (1).

Note: Common hardware items known to be readily available in Army supply will be assigned Maintenance

Codes only. Source Codes, Recoverability Codes, and Quantity Authorized i1 will not be assigned to this

category of item.

(1) Source Code, indicates the selection status and source for the listed item.

Source codes are:

Code Explanation

Applied to repair parts which are stocked in or supplied from GSA/DSA or Army s pply system, and

authorized for use at indicated maintenance categories.

(2) Maintenance Code, indicates the lowest category of maintenance authorized to install the listed item. The

Maintenance level code is:

Code

Explanation

Operator/crew

b. Federal Stock Number, Column (2). This column indicates the Federal stock number for the item.

c. Description, Column (3). This column indicates the Federal item name and any additional description of the

item required. A part number or other reference number is followed by the applicable five-digit Federal supply

code for manufacturers in parentheses. Repair parts quantities included in kits, sets, and assemblies are

shown in front of the repair part name.

d. Unit of Issue, Column(4). This column indicates the unit used as a basis for issue, e.g., ea., pr, ft, yd, etc.