TM 55-1930-209-14&P-1
6-7.3.4 Shore discharge hose deployment status lights
NOTE
When shore discharge hose is deployed during periods of darkness, maritime
regulations require that status lights be shown on forward mast in following
sequence and scheme: red on top, white in middle, and red on bottom. During
daylight hours, black signal shapes must be displayed on forward mast in
following sequence and scheme: round on top, diamond in middle, and round on
bottom.
a.
Plug three status light plugs into receptacle on top of deckhouse.
b.
Close circuit breaker 5P14 on 24 Vdc power panel (Figure 6-10) to turn red and white status lights ON.
6-7.3.5 Anchor light. Close (ON) circuit breaker 7P14 on 24 Vdc power panel (Figure 6-10) to turn white anchor light
ON.
NOTE
When barge is anchored at night, maritime regulations require that a white anchor
light be displayed.
6-7.3.6 Navigation running lights. Close circuit breaker 2P14 on 24 Vdc power panel (Figure 6-10) to turn
navigation lights ON (starboard side green light, portside red light, and white stem light).
6-7.4 Shutdown procedures
6-7.4.1 Exterior side lights
a.
Turn bow and port exterior lights OFF by operating PORT & BOW EXTERIOR LIGHTS rotary switch located in
ROWPU space by dayroom door.
b.
Turn aft and starboard exterior lights OFF by operating STARBOARD & STERN EXTERIOR LIGHTS rotary
switch located in ROWPU space by dayroom door.
6-7.4.2 Floodlights
a.
Turn bow floodlight OFF by operating BOW FLOODLIGHT rotary switch located on weatherdeck on deckhouse
forward bulkhead.
b.
Turn aft floodlights OFF by operating STERN FLOODLIGHTS rotary switch located on weatherdeck on
deckhouse aft bulkhead.
6-7.4.3 Searchlights. Turn the rotary ON/OFF switch located on searchlight base to OFF.
6-7.4.4 Shore discharge hose deployment status lights. Turn red and white status lights OFF by opening circuit
breaker 5P14 on 24 Vdc power panel (Figure 6-10).
6-7.4.5 Anchor light. Tun anchor light OFF by opening circuit breaker 7P14 on 24 Vdc power panel.
6-7.4.6 Navigation running lights. Turn navigation lights OFF by opening circuit breaker 2P14 on 24 Vdc power panel.
6-7.4.7 After operation checks
a.
Turn off lights that are not needed.
b.
Check for damaged, loose or frayed cables, loose connections, or missing securements and fasteners. Repair,
replace, or tighten as necessary.
c.
Clean lighting panels and switches with a dry, lint-free cloth or with a vacuum cleaner.
6-16
