ENCLOSED CONDUCTOR SYSTEM CURRENT COLLECTORS Part No. No. Reqd. Part Name 70 E 3 Collector Assembly 601 BC 1 Clamp only 601 85 1 Swivel only 601 P 1 Post 601 E 1 Standard Arm 701 Y 1 Yoke 707 2 Case Half 70 S 1 Shoe 100 Z 1 Spring COM 1 1 --16 Hex Nut COM 2 1 S Lock washer COM 3 1 - 16 x 11/2 Bolt COM 5 1 1/4 - 24 Hex Nut COM 6 1 1/4 Lock washer COM 7 1 1, / _ 20 1/2 Bolt COM 8 2 ', / x 1 14 Roll Pin COM 10 1 No.  6 Non-Insulated Terminal COM 11 1 '/2 Retaining Ring *  Two  assemblies  required  for  single  phase  installation *Three assemblies required for three phase installation Note:  For number 100 E Collector Assembly Parts List Refer to Page 53. Number Required Per Installation Key Single Three No. Part Name Phase Phase 5-960   Collector Bar Bracket 2 2 S-961  Collector Bar - Short (Specify whether for Single or Three Phase, Size of I-Beam and Capacity of Hoist) 2 1 S-962  Collector Bar - Long (Specify Size of I-Beam and Capacity of Hoist) 0 1 S-963  Collector Bar Insulator - Short 2 1 S-964  Collector Bar Insulator - Long 0 1 S-965  Collector Bar Bracket Attaching Screw 4 4 S-966  Collector Bar Bracket Attaching Screw Lock washer 4 4 S-968  Collector Bar Bracket Set Screw   4 4 Specify  whether  for  Single  or  Three  Phase,  size  of  I- Beam and Capacity of Hoist. *These components are also used with wheel and shoe type current collectors shown on page 52. 38