TM 55-1930-209-14&P-15
CHAPTER 3 WORKSHOP EQUIPMENT AND ROWPU SPACE ARC WELDER
Section I. Description and data
3-1 Description. Workshop equipment shown in Figure 3-1 includes both operational and nonoperational items.
Operational equipment includes an arbor press, drill press, and grinder with dust collector. Nonoperational equipment
includes stowage bins and workbench with vise. Workshop equipment includes an arc welder in the ROWPU space
portside, under the air compressor motor controller near the life preserver stowage box. In addition, the air conditioning
unit (TM 55-1930-209-14&P-16), battery charger and inverter, isolating receptacle and 24 Vdc power panel
(TM 55-1930-209-14&P-9) are located in the workshop. Workshop equipment, as installed, is shown on drawings listed in
Appendix A. Electrical hookup is also shown on drawings listed in Appendix A. Additional information about operational
equipment is in the manufacturers' service manuals in Appendix B.
3-2 Equipment specifications
a. Jaw vise
Manufacturer
Reed Mfg. Co.
CAGEC
50171
Part no.
104-S
Supplier
McMaster-Carr Supply Co.
CAGEC
39428
Model no.
5287A3
Jaw width
4 in.
Maximum opening
6 in.
Material
Steel
Quantity
1
b. Drill press (drilling machine)
Manufacturer
Rockwell International
CAGEC
83738
Model no.
17-543
Capacity
5/8-in. cast iron
Motor
1/2 Hp, 1740 rpm, 440 Vac, 3 Ph, 60 Hz
Spindle speed
350-4250 rpm
Quantity
1
c. Grinder
Manufacturer
Baldor Electric Co.
CAGEC
05472
Model no.
8123W-DC8
Specification no.
68-166-13
Type
Pedestal w/dust collector
Frame
524 m
Wheel diameter
8 in.
Motor
3/4 Hp, 3450 rpm, 440 Vac,
3 Ph, 60 Hz
Dust collector
Part no.
DC8, Series A
Specification no.
34-168-167
Total flow rate
440 cf m
Motor
1/2 Hp, 3600 rpm, 120 Vac,
1 Ph, 60 Hz
Quantity
1
3-1
