TM 55-1930-209-14&P-3
b.
Remove and replace filter as follows.
(1)
Wipe dirt from oil filter (Figure 4-4). .
(2)
Remove and discard filter.
(3)
Clean the filter base and remove all old gasket material.
(4)
Lightly coat filter gasket with engine oil.
(5)
Install new filter Hand tighten an additional 3/4 turn after gasket contacts the base.
c.
Fill crankcase with 9 gallons of oil.
d.
Start and run engine to operating temperature Check for leaks.
.
.
Figure 4-4. HP Pump Diesel Engine Oil Filter.
.
e
Reduce engine speed to Idle Check oil level with dipstick. Add oil as necessary.
f.
Shut down engine.
4-7.3.2 Draining water from diesel engine fuel filter. Drain water and sediment from the fuel filter (Figure 4-5) at the
start of each shift.
4-7.3.3 Diesel engine alternator fan belt adjustment. Adjust HP pump diesel engine alternator fan belt (Figure 4-6) as
follows.
a.
Remove three nuts, bolts, lockwashers, and flat-washers Remove alternator guard.
b.
Place straight edge from vibration damper pulley to alternator pulley.
c.
Using a ruler, press down on fan belt halfway between pulleys Measurement should be 3/8 to 1/2 inch.
d.
If fan belt needs adjustment, proceed as follows.
(6)
Loosen jam nut and bottom mounting nut.
(7)
Use adjusting nut to adjust fan belt.
(8)
When adjusted, tighten bottom mounting nut and jam nut.
e.
Install alternator guard Install three flatwashers, lockwashers, bolts, and nuts.
4-18
