DECKMASTER
coding examples:
single unit, as illustrated to left, when specified as a
pump-code sequence is as follows:
SINGLE PUMP .......................................... component
1. PUMP .................................................................. P
2. SERIES............................................................... 15
3. MODEL ................................................................H
4. SHAFT END COVER ....................................... 300
5. PORT END COVER ...........................................BE
6. GEAR HOUSING ........................................... RL20
7. DRIVE SHAFT ..................................................... 2
UNIT CODE NUMBER
P15H300BERL20-2
reference to specifications
ROTATION
Rotation on all COMMERCIAL Model H pumps and
motors must be specified so that inlet and outlet porting
sizes and locations can be properly selected. Rotation
is orientated by looking at the shaft end of the unit.
When the drive shaft is above horizontal center line of
the unit, right and left sides are right and left
respectively. When the drive shaft is toward the bottom,
the side to your right is the established left side and the
side to your left is the established right side of the
device. COMMERCIAL pumps are built for clockwise
rotation, counterclockwise rotation or for rotation in
either direction. COMMERCIAL motors are always built
for rotation in either direction.
SHAFT END COVERS
Determine and specify code number for shaft end cover
desired. 15H pumps and motors are furnished in styles
for flange or pad mounting. Numerical code breakdown:
First digit indicates direction of rotation. It is important
that rotation desired be specified by proper code
number. Last two digits indicate shaft end cover pattern
which links particular shaft end cover to proper drive
shafts. When ordering shaft end cover, complete
CODE number must be 'specified. Details of each style
shaft end cover are shown on pages 22 thru 25.
PORT END COVERS
Determine and specify code number for port end cover
desired. 15H pumps and motors are furnished in two
basic porting arrangement-no porting and end porting.
Single and tandem pumps and motors are furnished with
recessed head type fasteners. Details of each style port
end cover are shown on pages 26 and 27.
GEAR HOUSINGS
Determine and specify code number for each pump or
motor gear housing desired. 15H pumps and motors are
furnished with tapered thread, SAE split flange or
straight thread fittings. Port selection includes no
porting, left and/or right hand side porting. Gear sizes
range from 1/2" to 2". Details of each style gear housing
are shown on pages 28 through 31.
SHAFTS
Determine and specify code number for shaft desired.
15H pumps and motors are furnished with splined or
straight keyed shafts. When selecting, drive shaft must
be coordinated with proper shaft end cover as
designated by pattern number. Pattern number only
links drive shafts to proper shaft end cover. Shafts must
be ordered by CODE number. Details of each style
shaft are shown on pages 32 and 33.
BEARING CARRlERS for tandem pumps and motors
only
Determine and specify code number for bearing carrier
desired when selecting a tandem unit. One bearing
carrier must always be placed between two adjacent
pumps or motors. 15H pumps and motors are furnished
with tapered thread, SAE split flange and straight thread
fittings. Port selection includes no porting, left and/or
right ,and side porting. Internal drilled ports must be
selected for proper direction of oil flow into adjacent
pumps or motors. Details of each style bearing carrier
are shown on pages 34 and 35.