OPERATINGPROCEDURE1.0Remove pump from container and inspect for damage.1.1Make necessary connections to advance and retract ports of valve. If hoses are used connect hose half couplerto one end of each hose remove plastic pipe plugs in ports and thread other end of hose into proper ports. Besure all connections are tight.1.2Place pump in horizontal position and remove pipe plug (item No. 25) and check oil level. Oil should be visibleat bottom of hole. If necessary fill to bottom of hole with Simplex Hydraulic Oil or equivalent. CAUTION: Do notover fill or add oil if ram being used with pump is in the raised position. Install breather plug in place of pipe plug(item No. 25). The breather plug is in bag attached to pump. CAUTION: Failure to install the breather plug canresult in damage to the equipment.1.3Connect hose half coupler on end of hose to ram half coupler on ram taking care to assemble hose fromadvance port of pump to bottom of ram and hose from retract port of pump to top of ram. Be sure knurled nutson couplers are tight. CAUTION: Failure to have couplers tightly connected can result in injury or damage to theequipment.1.4To extend cylinder, move control handle to advance position and pump on handle. CAUTION: Do not attempt toexceed rated cylinder capacity or plunger stroke.1.5To retract cylinder, move control handle to retract position and pump on handle. CAUTION: Do not continuepumping after cylinder has reached its maximum retracted position.1.6Extend cylinder plunger several times to purge air from the system. The cylinder should be lower than the pumpand there should be no load on the ram.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
