TM 55-2090-201-14&P
4-31. SECOND STAGE SEPARATOR - TYPE C AND D (Continued)
L O C A T I O N
ITEM
A C T I O N
R E M A R K S
12.
It is important that the filter element by handled
properly.
DO NOT touch or handle the sock area
(side covering) of the element. Contamination of
this surface by skin oils may prevent the coaleser
element from functioning properly and cause
foaming of the effluent.
b. Place filter element (7)
over the threaded element
stand (9).
Position the
element so that it is
centered over the element
positioning guide (10)
attached to the striker
plate (11).
c. Replace and center the
hold-down plate (6) over
the end cap of the filter
element.
d. Place O-ring (5), O-ring
retainer(4),
and wing nut
(3) on the element stand.
DO NOT use a wrench to tighten the wing nut, or the
filter element may be damaged.
e. Tighten the wing nut (3)
as tight as possible by
hand.
Cover
a. Install the cover (2).
b. Secure the cam bar (1) to
the cover by turning down-
ward to lock in place.
4-148
