TM 10-4610-232-12
3-38. REPAIR HEAT LAMP ASSEMBLIES. This task covers:
a. Removal.
b. Installation.
INITIAL SETUP.
General Safety Instructions:
Tools:
Screwdriver from storage box no. 2
WARNING
Materials/Parts:
Lamp bulb that has been on will burn skin. Wait
Lamp 500 watt (Appx E, Sec II, Item 47)
until lamp cools and use suitable cloths when
performing maintenance to avoid being burned.
Equipment Condition:
Heat lamp cable (1, Figure 3-22) disconnected
from outlet at van.
REMOVAL.
a.
Refer to Figure 3-22 and loosen three wing nuts (2), pivot wing nuts and studs (3) off frame (10).
b.
Swing cover (4) off frame (10).
c.
Remove lens (5).
d.
Depress clamps (6) with screwdriver and remove bulb (7) by pulling straight out of connector (8).
INSTALLATION.
a.
Install bulb (7) by pressing it into connector (8).
b.
Install lens (5) on positioning washer (9). Swing lens cover (4) into place, pivot studs (3) with wing nuts (2) onto frame (10)
and tighten wing nuts (2).
Figure 3-22. Heat Lamp
3-66