3-46. WIRING HARNESS W1 MAINTENANCE - continued.
Procedures are typical and can be used for all wiring harnesses and wire leads in the
Refer to wiring diagram in Appendix F for wiring harness being repaired.
Lay out wiring harness on a flat surface.
For wires attached to a female multipin connector, do step b.
For wires attached to an male multipin connector, go to step c.
Tag all wires before removal.
Using soldering gun, unsolder wires (10) from terminals (9) and remove wires. Tag and remove faulty wire.
Loosen two screws (3) securing clamp (5) to wiring harness (4)
Unscrew coupling (6) from shell (8) and slide coupling (6) and insulator bushing (2) clear of shell (8).
Using soldering gun, unsolder wires (1) from terminals (7). Tag and remove faulty wire.