TM 10-4320-317-13
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
PARAGRAPH TITLE
PARAGRAPH
Common Tools and Equipment ................................ ................................ ................................ ................ 5-1
Introduction ................................ ................................ ................................ ................................ .............. 5-4
Repair Parts................................ ................................ ................................ ................................ .............. 5-3
Special Tools; Test, Measurement, and Diagnostic Equipment;
and Support Equipment ................................ ................................ ................................ ............................ 5-2
Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE
AND SUPPORT EQUIPMENT
5-1. Common Tools and Equipment. Appendix B, Section III contains the authorized common tools. For authorized
equipment, refer to Modified Table of Organization and Equipment (MTOE) applicable to your unit.
5-2. Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. No special tools;
test, measurement, and diagnostic equipment; or support equipment are required for the repair of the pump unit.
5-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 10-
4320-317-23P.
Section II. MAINTENANCE PROCEDURES
PARAGRAPH TITLE
PARAGRAPH
Pressure-Reducing Control ................................ ................................ ................................ ...................... 5-5
Main Valve Assembly ................................ ................................ ................................ ............................... 5-6
Pressure-Reducing Control Valve Assembly Skid ................................ ................................ ..................... 5-7
5-4. Introduction. This section contains instructions covering maintenance functions for the direct support level on the
TWDS.
NOTE
Personnel required are listed only if the task requires more than one. After completing each
maintenance procedure, perform an operational check to ensure that equipment is properly
functioning.
5-1
