TM 10-4610-215-10
TM 08580A-10/1
LEGEND
1. Lens Cap
2. Lamp Bulb
3. Gasket Washer
4. Lamp Base Holder
Figure 3-16. Switch Indicator Lamp Replacement
b. Installation.
(1) Replace bulb (2) with lamp puller in Storage Box No. 2.
(2) Cover the lamp base holder (4) with gasket washer (3).
NOTE
Clean lens cap (1) before reassembly.
(3) Screw on lens cap (1).
3-11. REPLACING LAMP IN THE PANEL LIGHT (refer to fig. 3-17).
a. Removal.
(1) Using flat-tip screwdriver, loosen setscrew (1), observing position of shield.
(2) With your fingers, unscrew guard (2), lens (3), and bulb (4) from lamp base (5).
NOTE
Lens must be cleaned before installation.
b. Installation.
(1) With your fingers, screw bulb (4), lens (3), and guard (2) into lamp base (5).
(2) Position shield in same position it was in before you removed it.
3-35
