TM 10-4610-215-24
TM 08580A-24/2
f. Repair or Replace.
(1) Replace all damaged nuts, bolts, screws, and washers.
(2) Replace gasket.
(3) Replace damaged or worn electrical wires.
(4) Replace damaged power receptacle cover.
(5) Replace damaged or unserviceable power receptacle assembly.
(6) Send unusable parts and components to Direct Support
g. Installation. (Figure 2-68)
WARNING
Maintenance for repair.
ELECTRICAL HIGH VOLTAGE
Electricity can cause serious injury or death. Be certain that all
power is removed before performing maintenance on electrical
equipment.
(1) Connect three tagged wires (10) to rear of power receptacle (11).
(2) Carefully hold receptacle (11) in mounting hole of mounting panel (12) with test button (T) on
right–hand side.
(3) Insert four screws (9) through mounting panel (12) and receptacle (11).
(4) Install four flat washers (8), four lockwashers (7), and four nuts (6) on screw (9).
(5) Insert two screws (3) through cover (4), replacement gasket (5), mounting panel (12), and receptacle
(11).
(6) Install two lockwashers (2) and two nuts (1) on screws (3).
2-62. TERMINAL BLOCKS.
a. General. Removable terminal blocks are used in two places on the ROWPU. In the junction box assembly,
they distribute power from the generator set to the junction box assembly components. In the control box
assembly, they are the connection between the junction box assembly and the switches of the control box
assembly. This paragraph describes removal, inspection, and installation of the terminal blocks.
b. Removal. (Figure 2-69)
WARNING
ELECTRICAL HIGH VOLTAGE
Electricity can cause serious injury or death. Be certain that all
power IS removed before performing maintenance on electrical
equipment.
(1) Remove all screws (1) that hold wire lugs (2) to terminal block (7). (Refer to schematic, figure 1-12.)
(2) Remove wire lugs (2) from terminal block (7).
(3) Remove four nuts (3), four lockwashers (4), and four flat washers (5) from screw (6).
(4) Remove screw (6) from terminal block (7) and junction box assembly or control box assembly.
(5) Remove terminal block (7) from junction box assembly or control box assembly.
2-134
