TM 10-4610-215-24
TM 08580A-24/2
m. R.O. Vessel End Cap Assembly Installation. (Figure 2–86) (ARMY)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Install O–ring (4) to product water tube (6).
Install O–ring (17) on end plug (8).
Insert product water tube (6) through end plug (8).
Install spring clip (5) on product water tube (6).
Insert feed port (12) through end plate (9) and install spring clip (10).
Install O-ring (11) in slot on end plug (8).
Put together end plug (8) and end plate (9) and secure using Allen screws (7).
Install O-ring (13) on end plug (8).
NOTE
There are two O–rings (one red and one yellow) inside end
connector. Red faces end cap and yellow the elements. Make
sure orientation is correct.
Install red O–ring (15) and yellow O-ring (16) in end connector (14).
(1 O) Install end connector (14) on product water tube (6).
(11 ) Align end cap as previously marked and install end plate (9) on studs (3) and secure using ten
lockwashers (2) and ten nuts (1).
n. R.O. Vessel End Cap Assembly Installation. (Figure 2-87) (USMC)
(1) Install O-ring (17) on end plug (8).
NOTE
There are two O–rings (one red and one yellow) inside end
connector (14). Red faces end cap and yellow faces the
elements. Make sure the end connector is installed correctly.
(2) Install red O-ring (15) and yellow O-ring (16) in end connector (14).
(3) Install end connector (14) on product water tube (6).
(4) Insert product water tube (6) through end plug (8).
(5) Install O-ring (13) on product water tube (6).
(6) Insert feed port (12) through end plate (9) and install spring clip (10).
(7) Install O-ring (11) in slot on feed part (1 2).
(8) Put together end plug (8) and end plate (9) and secure using Allen screws (7).
(9) Install spring clip (5) on product water tube (6).
(10) Screw hose adapter (4) on product water tube (6) using Teflon tape.
(11 ) Align end cap with previously marked markings and install end plate (9) on studs (3) and secure using
ten lockwashers (2) and ten nuts (1).
2-171
