TM 10-4610-215-24
TM 08580A-24/2
(8) Remove two nuts (22) and two washers (29) from two screws (18) through terminal block (15).
(9) Remove two screws (18) and terminal block (15) from cover (34).
(10) Remove two screws (27) and timer motor assembly (25) from timer mechanism assembly (17).
NOTE
Mark six cams and timer mechanism plate to assure proper
alignment during reassembly.
(11) Loosen, but do not remove, three setscrews (1 6).
(12) Remove lower fill cam (23) and upper fill cam (24) from timer mechanism assembly (17).
(13) Remove screw (33) and washer (32) from three cams (31), (30), and (28).
(14) Remove upper timer cam (31 ) two center cams (30), and decal-cam assembly (28) from timer
mechanism (17).
(15) Remove four screws (26), four locknuts (19), timer mechanism plunger (21 ), and timer mechanism
assembly (20) from cover (34).
d. Timer Centroller Disassemblv.
(1) Remove three screws (29) (figure 3-18, sheet 2 of 2), three lockwashers (30), and bracket (31) from
case assembly (1).
(2) Remove two screws (32) two compression springs (33), and pilot valve motor assembly (27) from case
assembly (l).
(3) Remove plastic lock cap (5), nameplate (4), cover (3), and solenoid valve assembly (9).
(4) Remove two elbows (13) and tee (16) from solenoid valve assembly (9).
(5) Remove electrical locknut (6) solenoid cover (2), and solenoid control switch (7) from case assembly
(1).
(6) Remove four screws (36), gasket (15), and controller assembly (19) from case assembly (1).
(7) Remove two screws (35) and plate (37) from controller assembly case (19).
(8) Remove two nuts (34) from two screws (18) through micro switch (39).
(9) Remove two screws (18), two washers (40), micro switch (39), and insulator (38) from plate (37).
3-87