TM 10-4610-215-24
TM 08580A–24/2
h. Timer Controller Reassembly.
(1) Install fitting (12) (figure 3-18, sheet 2 of 2), plug
valve assembly (14).
(2) Install pilot valve assembly (14) with three screws
(3) Install cam (26) on pilot valve assembly (14).
17), three tees (16), and two elbows (13) into pilot
(11) in controller assembly case (19).
(4) Install switch bracket (20) with two screws (25) through bracket and into pilot valve assembly (14).
(5) Install micro switch (21) and two insulators (22) on switch bracket (20), using two washers (23), two
screws (24), and two nuts (10).
(6) Install insulator (38), micro switch (39) on plate (37), using two washers (40), two screws (18), and two
nuts (34).
(7) Install plate (37) on controller assembly case (19) with two screws (35).
(8) Install controller assembly case (19) and new gasket (15) in case (1) with four screws (36).
(9) Install solenoid control switch (7), solenoid cover (2), and electrical locknut (6) on case assembly (1).
(10) Install two elbows (13) and tee (16) on solenoid valve assembly (9).
(11) Install solenoid valve assembly (9), cover (3), nameplate (4), and plastic lock cap (5).
(12) Install pilot valve motor assembly (27), two compression springs (33), and two screws (32) on case
assembly (1).
(13) Install bracket (31), three lockwashers (30), and three screws (29) on case assembly (1).
(14) Install seal strip (28) on case cover (1).
i. Timer Mechanism Reasse mbly.
(1) Install decal-cam assembly (28) (figure 3-18, sheet 1 of 2), two center cams (30), and upper timer
cam (31 ) on timer mechanism (17).
NOTE
Align pre-punched indexing marks on cam and timer mechanism
to assure alignment during reassembly.
3-90
