TM 10-4610-232-12
(2) Disconnect ground wire lug (7), which is attached to the accessory table by removing capscrew (1), (2)
DELETED, washer (3), nut (4), Iockwasher (5) and washer (6).
(3) Remove four capscrews (8), (9) DELETED, washers(10), nuts (11), Iockwashers (12) and washers (13), Remove
storage box (14).
b. Storage Rack (Figure 4-74). Remove twocapscrews (15), Iockwashers (16) and washers (17) and lift storage rack
(18) from wall.
Remove four nuts (19), Iockwashers (20), flat washers (21) and screws (22). Remove loading plan data plate (23).
REPAIR.
a. Replace damaged terminal (para. 4-10).
b. DELETED.
WARNING
Do not replace ground wire unless power is shut off.
c. Replace damaged ground wire (7).
d. Replace severely damaged storage box.
e. Replace severely damaged storage rack.
REASSEMBLY.
Assemble loading plan data plate (23) to underside of lid with four screws (22), flat washers (21), Iockwashers (20)
and nuts (19).
a. Storage Box.
(1) Position box (14) on table and install four capscrews (8), washers (13 and 10), Iockwashers (12), (9) DELETED,
and nuts (11).
(2) Connect ground wire lug (7) by installing washer (3), (2) DELETED, capscrews (1), washer (6), Iockwasher (5)
and nut (4).
b. Storage Rack. Position rack(18) on wall and secure with two capscrews (15), Iockwashers (16) and washers(17).
4-256 Change 2
