TM 10-4610-232-12
REPAIR.
a. Repair by replacing damaged harness assemblies and missing or faulty components.
b. Replace nameplate (para. 4-10).
c. Replace loose or damaged ring tongue connectors (para. 4-10).
d. Replace wire markers (para. 4-10).
e. Replace damaged rivnuts.
a. If removed, install nameplate (39) and secure with drive screws (38).
b. Subassembly 12 MOVS (37) on panel (34) and secure with screws (35) and washers (36).
c. Install panel (34) in box (6) and secure with screws (32) and washers (33).
WARNING
This junction box contains 440 volt power. Be absolutely certain that wires are
connected correctly and securely or injury or death may result. If there is any question
as to where any wire should be connected, consult your supervisor.
d. Place gaskets (25 thru 31 ) on harnesses(18 thru 24) and pass the wires of each harness (one at a time) through
the appropriate holes in box (6). Connect the wires in accordance with the tags placed during removal and sheet 2 of
Figure 4-86.
e. Varnish the connections.
f. Secure harnesses(18 thru 24) with screws (12), washers(14) and nuts (13).
g. Install dust covers (15, 16 and 17).
h. Close box(6) cover and secure with four latches (9) by tightening screws (7). Reassemble screws (7), washers(8),
latches (9), springs (10) and washers (11) within latch (9) if screws (7) were loosened too much.
INSTALLATION.
a. Place box (6) in position and secure with capscrews (1), washers (2), nuts (3), Iockwashers (4) and washers (5).
b. Install the cables on the junction box.
4-280 Change 2
