TM 10-4610-232-12
4-82. HIGH PRESSURE PUMP BELT GUARD. This task covers:
a. Removal.
b. Installation.
INITIAL SETUP.
Tools, see Appx B, Sec Ill, Ref Code (No.):
General Safety Instructions:
Tool Kit, General Mechanics Automotive (1)
WARNING
Equipment Condition:
ROWPU shutdown. High pressure pump circuit
Observe specific Warning in text.
breaker CB6 (63, Figure 2-4) turned OFF.
Do not wear jewelry or loose clothing while working
Material/Parts:
Lockwashers (TM 10-4610-232-24P)
Washers (TM 10-4610-232-24P)
on unit.
WARNING
Disconnect high pressure pump motor cables from junction box before attempting to
work on unit. Failure to do so could result in serious injury from electrical shock or
moving parts.
R E M O V A L .
NOTE
Note the position of the screen and spring nuts before removal.
Remove the twelve capscrews (1, Figure 4-97), lockwashers (2), washers (3), square washers (4) and remove screens
(5) and (6). Do not remove straight edge (7) unless necessary. Remove neoprene trim (8 and 9) if necessary.
Install neoprene trim (8 and 9). Install screens (5) and (6) using capscrews (1), Iockwashers (2), washers (3) and
square washers (4). Install straightedge (7).
Figure 4-97. High Pressure Pump Belt Guard
4-296 Change 2
