TM 10-4610-232-12
i.
Pack the threaded holes in hub (22) with grease to prevent corrosion.
j.
Place motor (17) on motor base (32) and secure with nuts (26). Do not tighten nuts (26) at this time.
k.
Install belt (19) over motor sheave (23) and air compressor drive sheave (not shown) with the tapered part of the
belt in the sheave grooves.
I.
Refer to para. 4-78 and adjust drive belt tension and sheave alignment.
m.
(Model WTA-060 only) Install elbow (16) and secure with conduit nut (15).
n.
(Model ROWPU-1 only) Install sealing washer (15A) and elbow (16) and secure with conduit nut (15).
o.
Slide nut (12), retainer (13) and bushing (14) on cable (1).
p.
Push cable (1) through into the electrical box on motor (17).
q.
Refer to Figure 4-93, sheet 2, and connect all wires as tagged during removal. Spray all connections with varnish
and tape and twine connections as shown.
r.
Refer to Figure 4-93, sheet 1, and tighten nut (12).
s.
Install cover (10) and gasket (11) and secure with screws (8) and washers (9).
t.
Install four clamps (7) and secure with screws (2), lockwashers (3), washers (4), nuts (5) and washers (6)
u.
Connect cable (1) at junction box.
WARNING
Do not attempt to change electrical connections as described below with power
applied to the motor. Serious injury or death could occur.
v.
Check motor rotation when started. It must be counterclockwise when viewing the sheave end of the motor. If it
is not correct, shut down the motor and check for correct connections. To reverse rotation, interchange the T1 and T2
connections in the electrical box on the motor.
Change 11 4-291
