TM 10-4610-239-24
TM 08580B-24/3
Table 2-2. Unit Troubleshooting - Continued
Malfunction
Test or Inspection
Corrective Action
SUSPENSION ASSEMBLY - Continued
4. TIRES WEAR UNEVENLY - Continued
If any axle is bent, replace defective axle. Refer to paragraph 2-65.
Step 2.
Check wheel bearing adjustment on each wheel. Refer to paragraph 2-65.
If wheel bearing adjustments are good, go to step 3.
If wheel bearings are out of adjustment, adjust wheel bearings. Refer to paragraph
Step 3.
Check trailer for proper loading.
If loading is improper, correct trailer loading.
If trailer is properly loaded, notify Direct Support Maintenance.
ROWPU ASSEMBLY
1. ROWPU LEAKS WATER
WARNING
ROWPU piping and assemblies may contain extremely high
pressure during and after operation. If this pressure is not
relieved before working on pipes or assemblies, serious injury or
death may occur. Be sure to open all drains and vents before
working on ROWPU.
Isolate water leak.
If any pipe is leaking, replace damaged pipe. Refer to paragraph 2-93.
If any gage is leaking, replace leaking gage. Refer to paragraphs 2-104 and 2-105.
If backwash valve is leaking, replace backwash valve. Refer to paragraph 2-101.
If multimedia filter is leaking, notify Direct Support Maintenance.
If multimedia filter control valve is leaking, replace multimedia filter control valve.
Refer to paragraph 2-86.
If diaphragm valve assembly is leaking, repair diaphragm valve assembly. Refer to
2-37
