TM 10-4610-241-24
TO 40W4-13-42
2-13.
INFORMATION AND DATA PLATES REPLACE.
This task consists of:
a.
Removal
b.
Installation
INITIAL SET-UP:
Tools Required
General Mechanics Tool Kit (Appendix B, Section III, Item 4)
Rivet Gun (Appendix B, Section III, Item 3)
Electric Drill (Appendix B, Section Ill, Item 3)
Grinder (Appendix B, Section III, Item 3)
Material/Parts Required
Detergent (Appendix C, Section II, Item 5)
Rags, Wiping (Appendix C, Section II, Item 14)
Rivets and Drive Screws
Equipment Condition
Reference
Power shut down (Power Source Manual).
a.
Removal.
WARNING
Keep data plates from falling into areas where they will be hard to retrieve and
pose a possible danger to equipment and personnel.
NOTE
Rivets and drive screws may be removed by drilling thru them and punching out
scraps with a drift pin, or by grinding or chiseling off the heads, then punching out
the stubs with a drift pin.
(1)
Remove rivets or drive screws (1).
(2)
Remove data plate (2).
b.
Installation.
(1)
Clean area to receive data plate with water, detergent and rags as necessary.
(2)
When area is clean and dry, install rivets (1) with a rivet gun, and drive screws (1) with a hammer.
(3)
If required, remove protective cover (i.e paper or wax covering) with detergent and rags.
2-80
