TM 10-4610-241-24
TO 40W4-13-42
2-23.
HOSE ASSEMBLIES REPAIR.
This task consists of:
a.
Disassembly
b.
Cleaning
c.
Inspection
d.
Repair
e.
Assembly
INITIAL SET-UP :
Material/Parts Required
Detergent (Appendix C, Section II, Item 5)
Rags, Wiping (Appendix C, Section II, Item 14)
Gaskets (TM 10-4610-241-24P)
Equipment Condition
Reference
Hose Assembly disconnected from System (TM 10-4610-241-10).
NOTE
ROWPU uses both, collapsible discharge hoses and noncollapsible suction hoses.
Repair of both type hoses is the same. One type hose is shown, the others are similar.
a.
Disassembly.
(1)
Disconnect plug (2) and coupling (10) from hose (12) end couplings.
(2)
Remove gaskets (1) and (11).
(3)
Remove key rings (3, 5, 6, 8 and 9) from plug (2), coupling (10) and hose assembly (12).
(4)
Remove plug (2) and coupling (10).
(5)
Remove chains (4) and (7) from key rings.
b.
Cleaning.
(1)
Wash all components with clean water and detergent.
(2)
Rinse components in clean water and dry with wiping rags.
c.
Inspection.
(1)
Inspect all components for cracks, wear and other visible damage.
(2)
Inspect hose (12) for cuts, tears, deep scratches and damaged or worn end couplings.
2-116
