TM 10-4610-241-24
TO 40W4-13-42
2-84. AIR CLEANER ASSEMBLY (BRAKES) REPLACE (WPES-10 AND H-9518-1).
This task consists of:
a. Removal
b. Service
c. Installation
INITIAL SET-UP:
Tools Required
General Mechanics Tool Kit (Appendix B, Section III, Item 4)
1-3/4 Inch Wrench (Appendix B, Section III, Item 3)
Goggles (Appendix B, Section III, Item 3)
Material/Parts Required
Tape, Anti-seize (Appendix C, Section II, Item 19)
Detergent (Appendix C, Section II, Item 5)
Rags, Wiping (Appendix C, Section II, Item 14)
Gasket and Filter Element (TM 10-4610-241-24P)
Equipment Condition
Reference
Power shut down (Generator Manual)
Leveling Jacks extended (TM 10-4610-24l-10)
Airbrake Hoses disconnected from Towing Vehicle (TM 10-4610-241-10).
General Safety Instructions
WARNING
Compressed air can blow dust into the eyes. Wear goggles and open drain cock slowly
to avoid a sudden rush of air when releasing reservoir pressure.
NOTE
There are two brake line air filters., one on each side of the flatbed cargo trailer. Both are
removed and installed the same. One is shown.
a.
Removal.
(1)
Turn drain cock (2) slowly to release air pressure from reservoir (1).
NOTE
Make sure that airflow from reservoir has stopped before closing dram cock (2).
(2)
Unscrew two tube assemblies (3 and 4) from air cleaner (9).
(3)
Support air cleaner (9) and remove two nuts (5) and one U-bolt clamp (6).
(4)
Remove air cleaner (9).
(5)
Remove two adapters (7 and 8) from air cleaner (9).
2-336 Change 1