TM 10-4610-241-24
TO 40W4-13-42
3-45. PUMP AND MOTOR STAND REPAIR (MODELS WPES-10, WPES-20 AND WPES-30) - continued.
d.
Inspection.
(1)
Inspect stand (3) for cracks and damage.
(2)
Inspect mounting hardware for excessive wear and damage.
e.
f .
(3)
Inspect footing plates (6 and 7) and mounting plate (18) for cracks and corrosion.
Repair.
(1)
Replace defective components.
(2)
Repair stand by welding as required (TM 9-237).
Assembly.
(1)
Thread nut ( 16) about halfway up on bolt (17).
(2)
Install bolt ( 17) on plate (18) to protrude about 2 inches.
(3)
Install pin (15) and position washer (14) on end of bolt (17).
(4)
Position plate (18) on stand (3) and push bolt (17) thru hole in stand.
(5)
Install washer (I 3) and pin (1 2).
(6)
(7)
Install four washers (11), bolts (10) lo&washers (9) and nuts (8).
Install footing plates (6 and 7) with lo&washers (5) and nuts (4).
g.
Installation
Stand is heavy/difficult to lift. Attempting to lift manually could result in injury. Use
lifting device rated at 500 lbs or greater to lift.
(1)
Using chain hoist, position stand (3) on ROWPU frame.
(2)
Install ten lockwashers (2), and screws (1).
3-256 Change 1
