OPERATOR AND UNIT MAINTENANCE MANUAL
(INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
FOR WATER QUALITY ANALYSIS SET: PURIFICATION (WQAS-P)
CORROSION PREVENTION AND CONTROL (CPC).
Corrosion Prevention and Control (CPC) of Army materiel is a continuing concern. It is important that any corrosion
problems with this item be reported so that the problem can be corrected and improvements can be made to prevent the
problem in future items.
While corrosion is typically associated with rusting of metals, it can also include deterioration of other materials, such as
rubber and plastic. Unusual cracking, softening, swelling, or breaking of these materials may be a corrosion problem.
If a corrosion problem is identified, it can be reported using Standard Form 368, Product Quality Deficiency Report. Use
of keywords such as "corrosion," "rust," "deterioration," or "cracking" will ensure that the information is identified as a
CPC problem. The form should be submitted to: Commander, U.S. Army TACOM, ATTN: AMSTA-TR-D/210, Warren,
MI 48397-5000; DODAC: W56HZV
OZONE DEPLETING SUBSTANCES.
This set does not contain Ozone depleting substances. (ODS)
DESTRUCTION OF ARMY MATERIEL TO PREVENT ENEMY USE.
Methods and/or procedures for the destruction of Army materiel to prevent enemy use are covered in TM 750-244-3,
"Procedures for Destruction of Equipment to Prevent Enemy Use".
PREPARATION FOR STORAGE AND SHIPMENT.
Refer to Work Package 0018 for specific instructions.
Myron L. Ultrameters, including the pH/ORP sensor, have a limited one year warranty. The warranty starts on the date
found in block 23 of DA Form 2408-9, Equipment Control Record.
If an instrument fails to operate properly, see Troubleshooting Chapter. The battery and pH/ORP sensor are user-
replaceable. For other service, return the instrument prepaid to the Myron L. Company.
MYRON L. COMPANY
6115 Corte Del Cedro
Carlsbad, CA 92009
If, in the opinion of the factory, failure was due to materials or workmanship, repair or replacement will be made without
charge. A reasonable service charge will be made for diagnosis or repairs due to normal wear, abuse or tampering. This
warranty is limited to the repair or replacement of the Ultrameter only. The Myron L. Company assumes no other
responsibility or liability.
The Turbidity Meter is warranted for a period of two (2) years against defects in workmanship and materials when used for
their intended purpose and maintained according to instructions. This warranty is limited to repair or replacement free of
charge. Damages due to accidents, misuse, tampering or lack of prescribed maintenance are not covered. If service is
required, contact the dealer from whom you purchased the instrument. If under warranty, report the model number, date of
purchase, serial number and the nature of the failure. First obtain a Returned Goods Authorization number from the
Customer Service department, then return the instrument with the Authorization # included along with shipment costs
prepaid. If the repair is not covered by the warranty, you will be notified of the charges. When shipping any instrument,
make sure it is properly packaged for complete protection. The warranty starts on the date found in block 23 of DA Form
2408-9, Equipment Control Record.