TM 10-6630-246-12&P
TM 09241B-12&P
4-12.
CARRYING CASE.
This task covers:
a.
Repair
b.
Replacement
INITIAL SETUP:
Equipment Condition
Materials/Parts
All components and manuals removed.
Rivets (24)
(Appendix D, section II and III)
(Appendix C, figure C-5, item 15)
Tools
Rivet
(Appendix C, figure C-5, item 2)
Drill Metal Cutting, 1/8 inch (3.175 mm)
(Appendix B, section III, item 2)
Tape, Double Sided
(Appendix C, figure C-5, item 10)
Drill Portable Electric
(Appendix B, section III, item 2)
Adhesive Remover
(Appendix F, item 22)
Riveter, Blind, Hand
(Appendix B, section III, item 3)
Adhesive Sealant (RTV)
(Appendix F, item 24)
Tool Kit, General Mechanics
(Appendix B, section III, item 1)
Adhesive
(Appendix F, item 21)
a.
Repair.
Repair is limited to replacement of individual components.
b.
Replacement.
(1)
Card and ring/chain assembly.
(a)
Remove insert (1).
CAUTION
Care must be taken when drilling case to avoid penetrating cavities behind rivets or exterior. Improper or
excessive drilling depth can cause case to leak and make it unusable.
(b)
Drill out rivet (2) being careful not to penetrate case half (3). Remove card (4) and ring/chain
assembly.
(c)
Remove split ring (5).
(d)
Remove chain fasteners (6) and (7) from chain (8).
(e)
Replace any damaged components.
(f)
Attach chain fasteners (6) and (7) to chain (8).
(g)
Attach split ring (5) to chain fastener (6) and card (4).
4-6
