TM 10-6630-246-12&P
TM 09241B-12&P
4-12.
CARRYING CASE. - continued
(h)
Position chain fastener (7) and secure to case half (3) using new rivet (2).
(2)
Nameplate.
(a)
Transfer all data from old nameplate (9) to new nameplate as needed.
(b)
Remove old nameplate (9).
(c)
Remove any adhesive from case half (10) using adhesive remover.
(d)
Secure new nameplate (9) to case half (10) using new double sided tape (11).
(3)
Gasket.
(a)
Remove old gasket (12) material.
(b)
Remove any adhesive from case half (10) using adhesive remover.
(c)
Apply a thin bead of adhesive into channel (13) and install new gasket (12).
(4)
Insert set.
(a)
Carefully remove old inserts (1) and (14).
(b)
Install new inserts (1) and (14) oriented per illustration.
(5)
Valve.
(a)
Remove insert (14).
(b)
Remove nut (15), washer (16), valve (17), and gasket (18).
(c)
Clean any adhesive sealant (RTV) from case half (10).
(d)
Coat new gasket (18) with adhesive sealant (RTV).
(e)
Install new valve (17) with new coated gasket (18) into case half (10).
(f)
Secure new valve (17) using new washer (16) and new nut (15).
(6)
Latch and latch clip.
CAUTION
Care must be taken when drilling case to avoid penetrating cavities behind rivets or exterior. Improper or
excessive drilling depth can cause case to leak and make it unusable.
NOTE
Procedures are typical for replacement of all latches and clips.
(a)
Drill out two rivets (19) being careful not to penetrate case half (3) or (10). Remove old latch (20)
or latch clip (21).
4-8
