TM 3-4230-209-10
2-17. HEATING WATER (CONT).
1
NOTE
The heater operating instruction plates provides additional heater oper-
ating instructions.
a. Open the storage compartment door (1) on top of the water heater. Leave it
open.
b. Remove the electrical power cable (2) from the storage compartment.
NOTE
One end of the power cable passes through the stuffing tube and is
connected inside the control box. Do not disconnect this end of the
power cable.
c. Uncap the HEATER RECEPTACLE AND SWITCH socket on the control panel
of the pump unit assembly and plug the free end of the power cable (2) into the
socket. Make certain that the power cable does not pass over the exhaust
stack.
d. Connect hoses necessary for mode of operation. Open valves necessary for
operation. Refer to STARTING PROCEDURE instruction plate on the pump unit
or following paragraphs for the specific operation required.
2-80
