TM 3-4230-218-30&P
2-6. GASOLINE ENGINE AND FAN ASSEMBLY - Continued.
a.
Removal.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
Loosen clamp (28) and disconnect flex hose (29) from muffler
(30).
Remove two nuts (27) and two lockwashers (26). Pull muffler
(30) and gasket (31) from engine (9) exhaust port.
Remove four bolts (22), four lockwashers (23), four washers
(21), and inlet cover (24).
Remove two bolts (4), two lockwashers (3), two washers (2),
and drain plate (1).
Remove four screws (17), four lockwashers (18), four washers
(19) and allow flange (20) to hang free.
Remove four nuts (16), four washers (15), ground strap (14),
and four screws (13) from engine mount (10).
Remove four bolts (5), four lockwashers (7), and four washers
(8) from front panel (5).
Carefully lower front panel (5) to gain access to internal termi-
nal strip.
On the terminal strip, remove the white wire that has a green
tracer from terminal 12.
Remove the yellow wire from terminal
6.
Carefully remove the wires from the back of the
control module box.
Do not remove other wires.
Slide the engine (9) and fan assembly (25) (refer to page 2-26)
and engine mount (10) out of the unit.
Remove fan assembly
(25) (page 2-26).
Remove four socket head screws (12) and four washers (11).
Remove engine mount (10) from engine (9).
2-22