TM 3-4230-218-30&P
2-9.
CARBURETOR - Continued.
e.
Assembly.
f.
(1)
(2)
(3)
(4)
(5)
(6)
Install washer (speed setting disk) (8) and screw (14). Install
washer (9) and spring (13). The end of the spring should be
placed in first hole from the slot on the disk as shown by asterisk.
Install lever (12). Insert the end of spring (13) into middle
hole of lever (12).
Install washer (10) and screw (11). Do not tighten screw.
Preload the spring by turning lever (12) one full turn and
making sure lever is pointed up. Seat lever (12) on throttle
shaft and tighten screw (11).
Engage needle valve (19) in slot of float (20) and position onto
carburetor body.
Secure float with tapered pin (15).
Install bowl (16), jet (17), and gasket (18).
Installation.
(see illustration next page)
(1) Install air cleaner (5) and tighten clamp (6).
(2) Connect linkage (3) to bottom hole in lever (12).
(3) Install carburetor (4) on engine intake manifold and tighten
clamp (2).
Be sure slot in carburetor alines with pin on mani-
fold.
2-42
