TM 5-3800-205-10-2
OPERATION UNDER UNUSUAL CONDITIONS - CONTINUED
0007 00
OPERATE IN EXTREME HEAT - CONTINUED
Parking Machine.
3.
a.
Park machine under cover, if possible. Cover windshield to protect against sand blasting.
b.
Ensure all tires are inflated to proper pressure.
c.
Check frequently for rust. Clean and lubricate machine to help prevent deterioration.
OPERATE IN MUD OR SOFT SURFACES
NOTE
It may be advisable to empty tank to determine mobility in mud or soft surfaces, and to traverse soft areas.
1.
Before entering mud or other soft surfaces, check conditions and engage differential lock. Select appropriate transmis-
sion gear range. Enter soft area at a medium speed for gear range selected.
2.
Maintain steady pressure on accelerator pedal to keep machine rolling until solid ground is reached. Do not accelerate to
point where wheels spin, if possible.
3.
If machine gets stuck, try to pull out slowly in a low gear. Boards, brush, or similar materials may be placed under tires
to provide traction.
4.
Notify Unit Maintenance to clean and inspect drive shaft for proper lubrication.
1.
Maintain steady, even movement with transmission in lower gears. Use differential lock as required. Try to keep
machine rolling without straining engine and powertrain. If machine gets stuck, notify Unit Maintenance.
2.
Whenever operating in sandy or dusty areas, you should:
a.
Service engine air cleaner more frequently.
b.
Make sure each tire has a valve cap.
c.
Check engine and transmission temperature and engine oil pressure frequently.
d.
If machine overheats, stop and perform troubleshooting procedures.
e.
Make sure engine oil filler tube and transmission fluid filler tube are cleaned before dipsticks are removed to check
fluid levels. Clean accumulations of sand and dirt from around fluid filler locations before checking or adding flu-
ids.
f.
Clean spouts of fuel containers and areas around filler caps on fuel tanks before adding fuel. Under extremely
sandy or dusty conditions, filter fuel when filling tanks.
g.
Cover windshield to protect against sand blasting.
h.
Notify Unit Maintenance to clean, inspect, and lubricate drive shaft more frequently.
OPERATE IN SNOW AND ICE
1.
Driving.
a.
Engage differential lock and accelerate slowly to avoid spinning tires.
b.
Drive at slower speeds.
c.
Give signals sooner.
d.
Apply brakes sooner to give early warning of intention to stop. This will also help to avoid skidding.
e.
Maintain double the normal distance from the vehicle ahead.
f.
Keep windshields, mirrors, and lights clean and free of snow and ice.
g.
If approaching a difficult stretch of road, stop and inspect road carefully before driving on it. Select transmission
gear range that best suits road condition. Use differential lock as required.
0007 00-7
