TM 5-3800-205-10-2
AIRDROP BY C-130 AIRCRAFT - CONTINUED
0018 00
RETURN MACHINE TO OPERATIONAL CONFIGURATION - CONTINUED
WARNING
If operating machine without ROPS/FOPS, drive with extreme caution, at low idle, and in 1st gear or reverse
ONLY. Machine has no rollover/falling object protection without ROPS/FOPS. Failure to follow this warn-
ing may cause injury or death to personnel or damage to equipment.
13.
NOTE: Machine is now drivable. However, until ROPS/FOPS is installed, it should be operated only with extreme cau-
tion, at low idle and in first gear or reverse ONLY. As required, move machine to a new location to complete reconfigu-
ration.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure any lifting device used is in good condition and of suitable lift capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may result in death or injury to person-
nel.
NOTE
ROPS/FOPS weighs 447 lb (203 kg).
14.
Install ROPS/FOPS on cab corner posts:
a.
Attach a suitable overhead lifting device to three lift points on top of ROPS/FOPS. Take up slack in slings.
NOTE
Tighten all mounting nuts using a crisscross tightening pattern. This will ensure even tightening and correct
installation alignment on all four cab corner posts.
b.
Lift ROPS/FOPS into position at four corner posts. While positioning ROPS/ROPS, loosely install all 16 bolts, 32
washers, and 16 nuts. Final tighten nuts in a crisscross tightening pattern to 317 lb-ft (430 Nm).
0018 00-29
