TM 5-3800-205-23-3
BRAKE AIR HOSE AND TUBE REPLACEMENT - CONTINUED
0013 00
AIR HOSE REMOVAL - CONTINUED
5.
Disconnect hose (7) from fitting (8) at quick-release valve (9).
NOTE
Note routing of hose to ensure correct installation.
6.
Cut tiedown straps and discard. Remove hose (7) from clamp at left-rear of water distributor and remove from machine.
7
8
9
AIR HOSE INSTALLATION
NOTE
To install air hose between top-rear of water distributor and quick-release valve at air/hydraulic brake
cylinder, perform steps 1-3 and 7-9.
To install air hose between draft frame and top-front of water distributor, perform steps 4-10.
1.
Position hose (7) between points of connection and route through clamp at left-rear of water distributor.
NOTE
Remove old antiseizing tape from fitting and apply new tape before connection is made.
2.
Connect hose (7) to fitting (8) at quick-release valve (9).
3.
Connect hose (7) to air tube (8). Secure hose with new tiedown straps.
4.
Connect hose (1) to air tube (8).
0013 00-5
