Page 8. Paragraph 5f is changed to read:
f. Dimensions and Weights, Including Carrier.
Overall length-------------------------------------------------------------------------------------------------------------319 inches
Overall width--------------------------------------------------------------------------------------------------------------96 inches
Overall height-------------------------------------------------------------------------------------------------------------112 inches
Overall weight:
Model W15A ---------------------------------------------------------------------------------------------------------20,050 pounds
Model W15B-9019 --------------------------------------------------------------------------------------------------23,000 pounds
Page 11. Paragraph 8d is changed to read:
d Inflate bitumeter wheel tire (12, fig. 2 and fig. 2..1) to 15 pounds.
Paragraph 8e is changed to read:
e. Check the engine flywheel shroud (9, figs. 11and 11.1).
Paragraph 8f is changed to read:
f. Inspect the engine housing (8, figs. 4 and 4.2), muffler (9), air cleaner (10), oil filter (6, fig. 11), air cleaner (7, fig.
11.1), and flywheel screen (12) for damage.
Page 12. Paragraph 8h, the first sentence is changed to read:
h. Visually check the water pump (6, figs. 4 and 4.2) and its connections for damage.
Paragraph 8i is changed to read:
i. Check the spray bars (14, figs. 4 and 4.2) and nozzle for damage.
Paragraph 8j is changed to read:
j. Check the water tank (7, figs. 4 and 4.2), water level gage (14, fig. 2), and fenders (8, fig. 8) for signs of damage.
Paragraph 8l is changed to read:
1. Raise and lower the fifth wheel (12, fig. 2) to see if the lift rod (3, fig. 5 and fig. 5.1) is working properly.
Spin the wheel to see if the bitumeter drive cable (6) and tachometer head (1) are working properly.
Paragraph 8m is changed to read:
m. Check the turn signal (2, figs. 3 and 3.1) and marker lamps (9, figs. 2 and 2..1) for proper operation.
Page 13. Paragraph 13, the first sentence is changed to read:
The engine primer control (11, figs. 4 and 4.2) is located on the engine rear panel.
Paragraph 14. The first sentence is changed to read:
The choke control (13, figs. 11 and 11.1) is located on the front panel beneath the low oil pressure safety switch.
Paragraph 15. The first sentence is changed to read:
The magneto stop switch (2, figs. 11 and 11.1) is located on the front panel to the left of the governor control knob (3).
Paragraph 17 is changed to read:
The starter button (1, figs. 11 and 11.1) located on the front panel to the left of the magneto ground switch (2).
Paragraph 19. The first sentence is changed to read:
The governor control (3, figs. 11 and 11.1) is located on the front panel below the oil filter assembly (6).
