TM 5-4320-216-20P
SECTION I.
IINTRODUCTION
1. Scope
Code
Explanation
This manual lists repair parts required for the
P Repair parts which are stocked in or supplied
performance of organizational maintenance of the
from the GSA/DSA, or Army supply system
pump.
and authorized for use at indicated
2. General
maintenance categories.
P2 Repair parts which are procured and stocked
This repair parts and Special Tools list is divided into the
for insurance purposes because the combat
following sections:
a. Prescribed Load Allowance (PLA)-Section II. A
or military essentially of the end item dictates
that a minimum quantity be available in the
composite listing of the repair parts, Special tools, Test
supply system.
and support equipment having quantitative allowances
M Repair parts which are not procured or
for initial stockage at the organizational level.
stocked, but are to be manufactured in
indicated maintenance levels.
A Assemblies which are not procured or stock as
authorized for the performance of maintenance at the
such, but are made up of two or more units.
organizational level in figure and item number
Such component units carry individual stock
sequence.
numbers and descriptions, are procured and
c. Special Tools, Test and Support Equipment-
stocked separately and can be assembled, to
Section IV. A list of special tools, test and support
form the required assembly at indicated
maintenance categories.
equipment authorized for the performance of
X Parts and assemblies which are not procured
maintenance at the organizational level (Not
or stocked and the mortality of which
Applicable).
normally is below that of the end item or
d. Index-Federal Stock Number and Reference
component. The failure of such part or
assembly should result in retirement of the
end item from the supply system.
ascending numeric sequence followed by a list of
X1 Repair parts which are not procured or
reference numbers in ascending alpha-numerical
stocked. The requirement for such items will
sequence, cross-referenced to the illustration figure
be filled by use of the next higher assembly
number and item number.
or component.
X2 Repair parts which are not stocked. The
Note. Items not illustrated are cross-referenced to
indicated maintenance category requiring
page number.
such repair parts will attempt to obtain same
through cannibalization. Where such repair
3. Explanation of -Columns
parts
are
not
obtainable
through
cannibalization,
requirements
will
be
The following provides an explanation of columns in
requisitioned,
with
accompanying
justification, through normal supply channels.
a. Source, Maintenance, and Recoverability
G Major assemblies that are procured with
Codes (SMR).
PEMA funds for initial issue only as
exchange assemblies of DSU and GSU
Note. Common hardware items known to be
level. These assemblies will not be stocked
readily available in Army supply channels are assigned
above DS and GS level or returned to depot
Maintenance codes only. Source codes, Recoverability
supply level
codes, and Maintenance Allowances are not assigned
(3) Maintenance code indicates the lowest category
this category.
of maintenance authorized to install the listed
item. The maintenance level code is:
(1) Source code indicates the selection status and
Code
Explanation
source for the listed item. Source codes are:
O -------------Organizational Maintenance
(3) Recoverability
code
indicates
whether
unserviceable items should be returned for recovery or
salvage.
Items not coded are expendable.
Recoverability codes are:
iii