B A S I C ISSUE ITEMS LIST
Section I. INTRODUCTION
C-1. Scope
assemblies at DSU and GSU level. These
assemblies will not be stocked above GS and DS
This appendix lists items which accompany the
level or returned to depot supply levels.
hypochlorination unit or are required for in-
(2) Maintenance code indicates the lowest
stallation, operation, or operator's maintenance.
category of maintenance authorized to install the
C-2. General
listed items. The maintenance level code is:
This basic issue items list is divided into the
Code
Explanation
following sections:
Operator / crew
C......
a. Basic Issue Items--Section II. A list of items
which accompany the hypochlorination unit and
(3) Recoverability code indicates whether
are required by the operator / crew for installation,
unserviceable items should be returned for recovery
opetation, or maintenance.
or salvage. Items not coded are expendable.
b. Maintenance and Operating Supplies--
Recoverability codes are:
Section III. (Not applicable.)
Code
Explanation
Applied to repair parts (assemblies and com-
R
C-3. Explanation of Columns
ponents) which are considered economically
The following provides an explanation of columns
repaiable at direct and general support
in the tabular list of basic issue items, section II.
maintenance levels. When the maintenance
a. Source, Maintenance, and Recoverability
capability to repair these items does not exist,
they are normally disposed of at the GS level.
Codes (SMR).
When supply considerations dictate, some of
(1) Source code indicates the selection status
these repair parts may be listed for automatic
and source for the listed item. Source codes are:
return to supply for depot level repair as set
Code
Explanation
forth in AR 710-50. When so listed, they will be
replaced by supply on an exchange basis.
Repair parts which are stocked in or supplied
P
Repair parts and assemblies which are
S
from the GSA / DSA or Army supply system,
economically repairable at DSU and GSU
and authorized for use at indicated maintenance
activities and which normally are furnished by
categories.
M
supply on an exchange basis. When items are
Repair parts which are not procured or stocked.
determined by a GSU to be uneconomically
hut are to be manufactured at indicated
repairable they will be evacuated to a depot for
mainteance levels.
A
evaluation and analysis before final disposition.
Assemblies which are not procured or stocked as
High dollar value recoverable repair parts which
T
such, but are made up of two or more units.
are subject to special handling and are issued on
Such component units carry individual stock
an exchange basis. Such repair parts are
numbers and descriptions, are procured and
normally repaired or overhauled at depot
stocked separately and can be assembled to
maintenance activities.
form the required assembly at indicated
Repair parts specifically selected for salvage by
u
maintenance categories.
reclamation units because of precious metal
X
Parts and assemblies which are not procured or
content, critical materials, or high dollar value
stocked and the mortality of which normally is
reusable casings or castings.
below that of the applicable end item or com-
ponent. The failure of such part or assembly
b. Federal Stock Number. This column indicates
should result in retirement of the end item from
the Federal stock number assigned to the item and
the supply system.
will be used for requisitioning purposes.
Repair parts which are not procured or stocked.
X1
The(requirements of such items will be filled by
c. Description. This column indicates the Federal
use of the next higher assembly or component.
item name and any additional description of the
X2
Repair parts, which are not stocked. The indicated
item required.
maintenance category requiring such repair
d. Unit of Measure (U / M). A two-character
parts will attempt to obtain them through
alphabetic abbreviation indicating the amount or
cannibalization. Where such repair parts are not
obtainable through cannibalization,
quantity of the item upon which the allowances are
requirements will be requisitioned, with ac-
based: e.g., ft, ea, pr, etc.
companying justification, through normal
e. Quantity Incorporated in Unit.
supply channels.
(Not applicable.)
G
Major assemblies that are procured with PEMA
f. Quantity Furnished With Equipment. This
funds for initial issue only as exchange
