TM 5-4610-218-12
nonmineral base cleaning solvent or soap and wa-
b. Disassembly.
ter.
(1) Refer
to figure 4-97 and disassemble the
(3) Inspect all threaded parts for damaged
left top side door.
threads.
(2) Refer to figure 4-98 and disassemble the
(4) Inspect the door for dents and misal-
counter-balance assembly.
ignment.
c. Clean, Inspect and Repair.
(5) Inspect door hinge and latch assembly for
(1) Clean all metal parts with dry cleaning
free operation.
solvent P-D-680.
(6) Inspect sesals and rubber stripping for
(2) Clean all seals and rubber stripping in a
cracks and signs of deterioration.
nonmineral base cleaning solvent or soap and wa-
(7) Repair or replace all parts that cannot be
ter.
restored to a serviceable condition.
(3) Inspect all threaded parts for damaged
(8) Repaint the parts that have been painted
threads.
if the paint is off or damaged.
(4) Inspect the door for dents and misal-
ignment.
and install the left bottom side door.
(5) Inspect door window glass, blackout panel,
and guides for damage.
4-81. Van Body Right Side and Rear Door.
(6) Inspect door hinge and latch assembly for
a. General. The right side and rear doors are
free operation.
identical in size and are hinged and check in the
(7) Inspect seals and rubber stripping for
same manner, but differ in other ways (fig. l-l).
cracks and signs of deterioration.
b. Removal. Refer to figure 4-101 and remove
(8) Repair or replace all parts that cannot be
the door and check assembly.
restored to a serviceable condition.
c. Disassem bly. Refer to figure 4-102 and disas-
(9) Repaint the parts that have been painted
semble the van body right side or van body rear door
if the paint is off or damaged.
and check assembly.
d. Reassembly. Refer to figure 4-97 and 4-98
d. Clean, Inspect and Repair.
and reassemble the left top side door and counter-
(1) Clean all metal parts with dry cleaning
balance assembly.
solvent P-D-680.
e. Installation. Refer to figures 4-95 and 4-96
(2) Clean rubber parts with soap and water.
and install the left top side door.
(3) Inspect all threaded parts for damaged
threads.
4-80. Van Body Left Bottom Side Door and
Counter-Balance Assembly.
(4) Inspect the rubber seals for cracks, and
signs of deterioration.
a. Removal.
(1) Open the top and bottom doors to their
(5) Inspect the door hinges and latches for
fullest extent and support the top door with a crane
binding.
or by some other suitable method.
(6) Inspect the door for dents, cracks, misal-
ignment, and other damage.
(2) Support the bottom door to prevent it from
dropping when the counter-balance is disconnected.
(7) Remove the dents from the doors, weld
cracked and broken parts.
(3) Refer to figures 4-99 and 4-100 and re-
move the left bottom side door and counter-balance
(8) Repair or replace all other damaged parts.
assembly.
e. Reassembly. Refer to figure 4-102 and reas-
b. Clean, Inspect and Repair.
semble the van body right side or van body rear door
and check assembly.
(1) Clean all metal parts with an dry cleaning
solvent P-D-680.
f. Installation. Refer to figure 4-101 and install
door and door check assembly.
(2) Clean all seals and rubber stripping in a
4-148
