TM 5-4610-218-12
d. Installation.
(4) Inspect all threaded parts for stripped or
damaged threads.
(1) Refer to figure 4-94 and install the efflu-
ent launder, agitator shaft assembly and down-
(5) Replace all damaged or defective parts.
comer.
(2) Install all drive components (fig. 4-37, 3-
48 and 4-41).
Section XXV. MAINTENANCE OF THE VAN BODY
WARNING
tenance functions for van body components.
b. Clean, Inspect and Repair.
Dry cleaning solvent, P-D-680, used to
(1) Clean all metal parts with dry cleaning
clean parts, is potentially dangerous.
solvent P-D-680.
A v o i d repeated and prolonged
(2) Clean all rubber parts with a nonmineral
breathing of the vapors and skin con-
base cleaning solvent.
tact with the liquid. Do not use near
open flame or excessive heat. Use in a
(3) Inspect all doors for cracks, dents, binding
well-ventilated area. The flash-point
of hinges or other signs of damage.
of P-D-680 is 100-138 F (38-59 C).
(4) Inspect all windows for broken glass or de-
fective seals and hinges.
4-78. Van Body.
(5) Replace all damaged or defective doors or
a. General. In most cases the van body can be re-
windows.
paired without removing the can body from the
(6) Repair cracks by welding and paint when
truck chassis. Subsequent paragraphs cover main-
required.
Section XXVI. MAINTENANCE OF THE VAN BODY DOORS,
ROOF HATCH, AND WINDOWS
WARNING
4-79. Van Body Left Top Side Door and Coun-
ter-Balance Assembly.
Dry cleaning solvent, P-D-680, used to
clean parts, is potentially dangerous.
a. Removal.
A v o i d repeated and prolonged
(1) Open the top and bottom doors to their
breathing of the vapors and skin con-
fullest extent and support the top door with a crane
tact with the liquid. Do not use near
or by some other suitable method.
open flame or excessive heat. Use in a
(2) Support the bottom door to prevent it from
well-ventilated area. The flash-point
dropping when the counter-balance assembly.
of P-D-680 is 100-138 F (38-59 C).
4-146
