TM 5-4610-218-34
rpm, volts, hertz, frame number, serial number,
k. The raw water or distribution pump identi-
phase, amperes, temperature rise, and code.
fication plate, located on the cover plate opposite
the drive end of the pump, specifies the manu-
p. The flow controller valve identification
facturer, type, serial number, gallons per minute,
plate, located on the front of the valve, specifies
and head feet of the pump.
the manufacturer and model number, and pro-
vides a scale to determine gallons per minute of
l. The filter pump motor identification plate,
water passing through the control valve.
located on top of the motor stator cover, speci-
fies the manufacturer, ac motor, horsepower,
q. The wiring identification plate is mounted
serial and frame number, rpm, volts, hertz,
in the van body. It specifies 24 and 120-volt wir-
phase, amperes, type, code, time rating, tem-
ing, and the color of the wire to the various com-
perature, rating, serial and manufacturer.
ponents.
m. The filter pump identification plate, lo-
r. The wiring diagram is mounted on the
cated on the pump housing, opposite the drive
inner side of the electrical control cabinet door.
end, specifies the manufacturer, type, number,
1-8.1. Differences in Models.
capacity, gpm, head feet, and serial number.
n. The heater identification and instruction
The Raider Model 72-PVC-Duplex chemical
plate, located on the front of the heater near the
solution feeder replaces existing chemical solution
controls, provides instructions for starting, oper-
feeders in all retrofit water purification units
ating, and stopping the heater. It specifies the
covered by this manual. Identification of retrofit
manufacturer, model and serial numbers, volt,
units must be accomplished by visual inspection
amperes and btu rating.
before operating the equipment. Procedures and
illustrations applicable only to the Raider Model 72-
o. The chemical slurry feeder motor identi-
PVC Duplex chemical solution feeder are identified
fication plate, located on top of the motor stator
by the designation "(Raider Model only)".
cover, specifies the manufacturer, horsepower,
1-12 Change 2
