W. W. PATTERSON COMPANY
V.S.E.Corporation
July 11, 1985
STORAGE PROCEDURES
Each of the four winches has been securely mounted to heavy-duty pallets for shipment and storage prior to installation.
Gross pallet weight is approximately 7000-lbs. and may be handled easily by a fork lift truck of sufficient capacity. In
addition, each winch is fitted with "lifting eyes" so that winch and pallet may be lifted as a unit by overhead crane.
No special storage procedures are required: enclosed oil-bath gearing, extensive use of stainless steel for all shafts, tie-
rods, spacers, clutches, brake drum components and fasteners, plus successive applications of inorganic zinc primer,
catalyzed epoxy primer and silicone alkyde enamel (two coats) on all carbon steel components assure long-time
corrosion protection under all likely conditions
PERFORMANCE CHARACTERISTICS
As required, characteristics of the Model 65-10-600I-1" Electric Anchor Winch are as follows:
Rated Line Pull (2nd. layer) ............................................................................................................................ 8000# prox.
Rated Line Speed (2nd. layer) .......................................................................................................................24 fpm prox.
Drum Capacity .......................................................................................................................... 600 ft. of 1" dia. wire rope
Electric Brake .....................................................................................................................................................105 lb. ft.
Power Supply ......................................................................................................................................... 10-HP, 208 volts,
3 phase, 60 Hertz,
TENV, 30-min. duty
Shock Load Capacity ...................................................................................................................................... 30-tons plus
Band Brake Capacity (Type 51)....................................................................................................................... 30-tons plus
PREVENTIVE MAINTENANCE
No matter how well constructed and protected, all machinery should have some preventive maintenance. However, due
to the extremely infrequent use to which these anchor winches will be subjected, any cautionary procedures are minimal:
(1) Lubricate the roller claims and sprockets after every voyage and before placing winches in operation;
(2) Lubricate the diamond shaft and guide bars of the level-wind also;
(3) Apply general purpose grease at all alemite grease
fittings;
Page 2
