TM 55-1930-209-14&P-19
Table 18-1. Preventive Maintenance Checks and Services for Double Drum Winch
B -
Before
D -
Daily
Q - Quarterly
D -
During
W -
Weekly
S - Semiannually
A -
After
M -
Monthly
A - Annually
INTERVAL
ITEM
PROCEDURES
EQUIPMENT
ITEM
TO BE
CHECK FOR AND HAVE
IS NOT READY/
NO.
INSPECTED
REPAIRED OR ADJUSTED
AVAILABLE IF
B D A D W M Q S A
AS NECESSARY
4
Fuel Tank
a. Check fuel level. Add fuel as necessary.
Class III leaks.
·
b. Check tank and lines for damage or
leaks. Repair or replace as required.
c. Check mountings and fittings for damage
or leaks. Repair or replace as necessary.
d. Check for loose or missing securements
and fasteners. Tighten and replace as
necessary.
5
Torque Converter
a. Check hydraulic fluid level and replenish
as necessary.
b. Check for leaks. If fluid loss is evident
Class III leaks.
with no sign of external leakage, remove
chain drive cover and inspect drive shaft
area for signs of hydraulic leaks. If leaks
are found, notify bargemaster or shift
leader so corrective action can be taken.
c. Check oil level on converter after running
unit for a few minutes. Add oil as neces-
sary.
d. Clean aspirator valve.
e. Remove inspection cover and oil clutch
release levers and link pins. Lubricate
clutch. Throw out bearing through the
grease fittings on the side of housing.
6
Air Compressor
a. Clean air compressor/air strainer element
every 150 hrs by immersing in cleaning
solvent and manually squeezing until ele-
ment is clean.
b. Dip clean element in lubricating oil and
squeeze it dry before replacing in
strainer.
7
Fuel Filter
Check for sediment and water in fuel filter.
Open drain cock at bottom of filter and drain
1/4 pint of fuel to remove sediment and
water.
18-4