TM 55-1930-209-14&P-3
(6)
Raise engine.
(7)
Remove 16 engine mounting bolts and lockwashers holding supports to engine Remove engine.
b.
Reinstall engine as follows:.
(1)
Install supports on engine Install 16 engine mounting bolts and lockwasher.
(2)
Install engine on slad assembly Install 12 engine support mounting bolts and lockwashers.
(3)
Remove lifting device from engine.
(4)
Install wire to fuel level sending unit.
.
(5)
Install lower hose on water pump Install two hose clamps on hose.
(6)
Install fuel lines.
(7)
Install power takeoff.
(8)
Install muffler pipe.
(9)
Install throttle control, KILL START lever, and engine start switch.
(10) Fill cooling system (paragraph 4-7.3.6).
(11) Install power cable assembly.
(12) Install batteries and battery cables.
4-8.3.2 Diesel engine alternator testing. Use a multimeter to test a questionable alternator as follows:.
a.
Remove battery cover.
b.
Set multimeter on 50-volt scale (use 100-volt scale if meter does not have 50-volt scale).
c.
Connect positive (+) lead to alternator cable that connects to positive battery terminal.
d
Connect negative (-) lead to alternator cable that connects to negative battery terminal.
.
e.
Start engine (paragraph 3-4).
.
f.
Multimeter reading should be 24 to 28 volts If not, replace alternator (paragraph 4-8.3.3).
g.
Disconnect multimeter negative (-) and positive (+) wires from battery.
h.
Install battery cover.
4-8.3.3 Diesel engine alternator replacement.
WARNING.
To prevent electric shock, ensure battery is disconnected before performing this procedure.
a.
Removal.
(1)
Disconnect battery.
(2)
Remove alternator cover.
(3)
Remove jam nut and loosen alternator adjusting nut (Figure 4-6).
(4)
Loosen mounting nut.
.
4-36
