DECKMASTER
6.1.3
Water Hose Line
The water hose line end termination as depicted in Figure 6-5 must be rigidly attached to the winch hub. The
winch hub incorporates a chute for the water hose line end termination to enter the inside of the hub and be clamped
using the Bolt-Down clamp depicted in Figure 6-6.
The suggested procedure for attaching the termination to the inside of the winch hub is as follows:
1) Using appropriate overhead handling equipment, position the water hose line termination down the
hub chute so that it is resting as shown in Figure 6-7.
Note:
a)
Termination will have to be pulled from the inside of the hub.
b)
Termination has a 9 inch maximum O. D. and chute maximum width is 9-1/2
inches. Extreme care must be taken because of the minimum clearance.
2)
Rigidly attach termination to chute base with Bolt-Down Clamp as depicted in Figure 6-6. All
necessary fastener hardware has been provided.
6-7
