TM    55-2090-201-14&P 3-3. OPERATORS    TROUBLESHOOTING    PROCEDURES    (Continued). Table    3-5. Test   Procedures   for   Electrical   and   Electronic   Components, Type   B   Separators   (Continued). Meter Reading Test    Procedure (VDC) Test    Conditions Remarks 3. (Continued) not   obtained. Refer  to  para- graph  3-49  for replacement   of mini-probe. C.  Connect  the test   meter leads   first to   contacts 6 and 9. Depress   the second   stage No.  2  oil  dump light/button (11). Connect   the test   meter leads  to contacts   7 and 9. Depress the   second stage  No.  2 oil  dump light/but- ton  (11). C. 24 0 A  24  VDC  read out  between contacts  6  and 9  indicates second   stage oil   discharge valve  (12)  and second   stage No.    2  oil  dump light/button (11)  is  receiv- ing  a  signal from  the  mini- probe   (6).   The printed   circuit board  is  func- tioning   proper- ly* A  zero read  out  be- tween   contacts 7  and  9  indi- cates   water discharge    valve (9)  and  circuit board are func- tioning    proper- ly. Replace  the  cir- cuit  board  if output   between contacts  6  and 9  is  less  than 24  ±5  VDC, or  greater  than 0  volts  between contacts  7  and 9.   Refer   to 3-35