TM 10-4610-215-24
TM 08580A-24/2
(7) Check lever pin mounting holes in lever and switch case for out-of-roundness.
(8) Check adjustment plate for flatness, cracks, or bent adjusting tang.
(9) Check lever for cracks or fractures.
(10) Check switch assembly for cracks, fractures, burned, or broken contacts.
f. Repair or Replace.
(1) Replace all gaskets, O-rings, and seals.
(2) Replace all damaged nuts, bolts, screws, and washers.
(3) Replace all broken, fractured, unusable, or unserviceable switch cases, piston cylinders, pistons, and
diaphragms.
(4) Replace all unserviceable switch assemblies, switch levers, adjustment plates, and lever pins.
(5) Replace low-pressure switch assemblies that are beyond repair or are unserviceable.
g. Reassembly. (Figure 316)
(1) Partially install adjustment plug (30) in switch case (5).
(2) From inside of switch case, install spring (27) and retainer (26).
(3) Hold lever (24) in place in switch case (5) and align mounting hole.
(4) Install lever pin (25) and lever (24) in switch case (5).
(5) Insert screw (22) and washer (23) through switch (1 9), Insulator (20), and adjustment
second mounting hole.
(6) Install nut (21 ) on screw (22).
plate
(7) Hold switch (19) with insulator (20) and adjustment plate (16) attached in place in switch case (5) and
align mounting holes.
(8) Install, but do not tighten. screw (17) and lockwasher (18) through switch (19), insulator (20),
adjustment plate (1 6), and switch case (5).
(9) Install, but do not tighten, screw (14) and lockwasher (15) through adjustment plate (21) and switch
case (5).
(10) Turn switch assembly upside-down.
(11) Insert piston (12) through bottom of switch case (5).
16). Align
3-80