TM 10-4610-215-24
TM 08580A-24/2
(1) Remove four screws (1) and four lockwashers (2) from cover (3), gasket (4), and switch case (5),
(2) Remove cover (3) and gasket (4) from switch body (5). Discard gasket,
(3) Turn switch assembly upside-down.
(4) Remove four bolts (6) and four lockwashers (7) from lower end fitting (8) and switch case (5).
(5) Remove lower end fitting (8) from switch case (5).
(6) Carefully remove spacer (11), pressure plate (1 O), and diaphragm (9) from switch case (5).
(7) Remove piston nut (13) and piston (12) through bottom of switch case (5).
(8) Turn switch over to operating position.
(9) Remove screw (14) and lockwasher (15) from adjustment plate (16) and switch case (5).
(10) Remove screw (17) and lockwasher (18) from switch (19), insulator (20), adjustment plate (16), and
switch case (5).
(11 ) Remove switch (19) with insulator (20) and adjustment plate (16) attached.
(12) Remove nut (21 ) from screw (22) and washer (23).
(13) Remove screw (22) and washer (23) from switch (19), insulator (20), and adjustment plate (16).
CAUTION
After lever pin is removed, the pressure on spring and retainer
will be relieved. Take care not to lose spring or retainer,
(14) Depress lever (24) with finger and carefully remove lever pin (25) from switch case (5).
(15) Remove lever (24) from switch case (5).
(16) Carefully remove retainer (26) and spring (27) from switch case (5).
(17) Remove setscrew (28) and soft copper slug (29) from switch case (5).
3-78
