TM 10-4610-215-24
TM 08580A24/2
f. Reassembly. (Figure 3-35)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
Install priming plug (23) in pump casing (2).
Install two petcocks (22) and adapter (24) in pump casing (2).
Place pump frame (14) in stand (21) and install lockwasher (20) and bolt (19) in pump frame (14).
Slide new slinger (17) over shaft of motor (18).
NOTE
Stationary seat and stationary seat gasket are part of the
mechanical seal. Replace entire mechanical seal during
reassembly.
On shaft of motor (18), install stationary seat gasket (16) and stationary seat (15).
Place motor (18) in pump frame (14) and align mounting holes.
Install four bolts (13) through pump frame (14) and motor (18).
Slide new mechanical seal (12) over shaft of motor (18).
Slide washer (1 1 ) over shaft of motor (18).
NOTE
Use a screwdriver in the slot provided in the fan end to hold the
motor shaft while assembling impeller and nut.
Install washer (9) and lockbolt (8) on shaft of motor (18).
Install impeller (10) on shaft of motor (18).
Install fan cover (7) with four screws (7A) to motor (18).
Hold diffuser (6) in place on pump frame (14) and align mounting holes.
Install two screws (5) through diffuser (6) and pump frame (14).
Install suction sleeve (4) to diffuser (6).
Hold pump case (2) and new gasket (3) in place on pump frame (14) and align four mounting holes.
3-148