TM 10-4610-215-24
TM 08580A-24/2
f. Reassembly. (Figure 3-37)
(1) Install two priming plugs (20) and (21), adapter (22), and petcock (23) in pump casing (2).
(2) Hold splash plate (18), slinger (17), and adapter (16) in place on motor (19) and align mounting holes.
(3) Install four bolts (15) through adapter (16), splash plate (18), and motor (19).
NOTE
Stationary seat and stationary seat gasket are part of the
mechanical seal. Replace entire mechanical seal during
reassembly.
(4) Install stationary seat (13) and stationary seat gasket (14) from inside cover (12).
(5) Install cover (12) on adapter (16).
(6) Install mechanical seal (11) on shaft sleeve (10).
(7) Slide shaft sleeve (10) on shaft of motor (19).
(8) Install shaft key (9) on shaft of motor (19).
(9) Install mechanical seal spring (8) on shaft sleeve (10).
(10) Install mechanical seal O-ring (7) on back of impeller (6).
(11) Place impeller (6) on shaft of motor (19).
(12) Install impeller bolt (4) with impeller bolt gasket (5) on shaft of motor (19).
(13) Place gasket (3) inside pump casing (2).
(14) Hold pump casing (2) in place on adapter (16) and align mounting holes.
(15) Install eight bolts, (four long (1A) and four short (1)) through adapter (16) and pump casing (2).
3-38. MULTIMEDIA FILTER ASSEMBLY.
a. General. This paragraph describes the removal, disassembly, cleaning, inspection, repair, assembly)
installation, and sanitization of the multimedia fitter assembly.
3-157
