TM 10-4610-215-24
TM 08580A-24/2
(3) Reach underneath to connect coupling on drain tube (32) (figure 3-48 sheet 2 of 2) to cartridge filter
(31).
(4) Position isolator (33) on frame floor aligning with mounting holes.
(5) Lower cartridge filter (31) to frame floor and align mounting holes.
(6) Install outlet pipe assembly (30) to cartridge filter (31).
(7) Wrap thread of four bolts with Teflon tape.
(8) Install four bolts (27), four lockwashers (28), and four nylon flat washers (29) through cartridge filter
mounting flange (31) and floor of ROWPU frame.
(9) Slide bracket (26) against cartridge filter (31) and tighten two bolts (25).
(10) Hold clamp (24) in place against cartridge filter (31) and ROWPU frame and align mounting holes.
(11 ) Insert two bolts (22) and two flat washers (23) through clamp (24) and ROWPU frame.
(12) Install two nuts (20) and two lockwashers (21) on bolts (22).
(13) Install flexible hose (18) (figure 3-48, sheet 1 of 2) on outlet pipe assembly (30) and tighten two hose
clamps (19).
(14) Connect tube coupling (17) to outlet pipe (30).
(15) Connect tube coupling (16) to cartridge filter (31).
(16) Connect quick-disconnect coupling (15) to top of cartridge filter (31).
(17) Connect tube coupling (14) to frame tubing.
(18) Install inlet pipe assembly (13) to cartridge filter (31).
(19) Install flexible hose (11) and hose clamps (12) to inlet pipe assembly (13).
(20) Tighten two hose clamps (12).
NOTE
Ensure that O–rings are in place on unions before connecting.
(21 ) Connect tube coupling (10) to inlet pipe assembly (13).
3-188
